
Before you replace, repair. StoneForge Paving & Masonry fixes sunken pavers, cracked driveways, loose steps, failing mortar joints and damaged chimneys. We find the cause of the damage so the repair lasts, and we tell you honestly when replacement is the better value.
Most paving and masonry problems start with water. Sunken pavers, cracked surfaces, loose steps and crumbling mortar usually trace back to a weak or washed-out base, poor drainage or open joints that let moisture in. Repairing only what you can see often means the problem returns, so we look at the cause first, whether that is the base, the pitch, the mortar or a downspout that dumps water in the wrong place.
A well-targeted repair is often more economical than replacing a whole surface. Resetting a section of pavers, patching a damaged area, rebuilding a failed step or repointing a wall can restore both the look and the strength. Our repair services include driveway and patio repairs, chimney repairs and repointing and brick and stone repointing.

Common questions about fixing worn paving and masonry.

If the damage is limited and the base is sound, repair is usually the better value. If the base has failed across a large area, replacement lasts longer. We inspect and explain both options.
We reuse original material wherever possible and source the closest match when units need replacing.
Look for crumbling, sandy or missing mortar, gaps between bricks or stones, and water staining. See brick and stone repointing.
Yes, we repair and repoint brick and stone chimneys. See chimney repair.
Sooner is better. Water gets into open joints and gaps, and each freeze-thaw cycle makes the damage worse, so early repairs usually cost less.
Pavers usually sink where the base has settled or washed out, where water collects, or where heavy loads or tree roots have disturbed the bed. We lift the affected area, rebuild the base and bedding layer and relay the same pavers, so the fix addresses the cause and not only the surface.
Mortar that is matched to the original masonry and applied after the old joints are properly cleaned out is meant to last many years. Using the wrong mortar can damage softer brick or stone, which is why we match the mortar to your walls and not simply fill the joints.
Loose bricks, open joints and a damaged crown let water into the chimney, and that water does more harm each winter, so early attention is worthwhile. We repair the masonry. If you have concerns about the flue or liner, a chimney specialist may also need to inspect it, and we will tell you if that is the case.